XLab Torpedo Versa/Hydroblade 3D Printed 24mm Clamp Set
$46.99
$33.08
(You save
$13.91
)
The Standard Has Changed
Most aerobars available today come in an industry standard diameter of 22.2 mm. This means that most XLAB athletes can purchase any of the TORPEDO VERSA, TORPEDO KOMPACT, or HYDROBLADE TRI front hydration systems and be confident that the stock SECURECLIPT BRACKETS included with these systems will fit their bikes.
Adapt, Overcome, And Evolve
However, there are some aerobar positions that are just a tad wider than the systems can go, or they have extensions that are larger than the standard 22.2 mm. For those setups, CUSTOM SECURECLIPT BRACKETS are available in theExtendedbracket set, and 3 alternate sizes; 27 mm, 25.4 mm, and 24 mm.
Environmentally Friendly
XLab select a biodegradable, extreme-impact, thermoplastic polymer when building these brackets in-house for added durability and strength.
24 mm: Oversized 24.0 mm extensions. Up to 150 mm wide extension positioning
HOW TO INSTALL
- Unscrew current clamps from front hydration system, keep screws to the side, you will use these later.
- Unthread the velcro strap from each clamp. If difficult, we found it is easy to dislodge the section of the strap lodged in top groove of the bracket first, by pushing up.
- Thread strap through the new 3D SECURECLIPT BRACKETS.
- Next, place the 3D SECURECLIPT BRACKETS onto your extensions at your desired position.
- Take the screws you set aside in step 1, and insert them into the 3D SECURECLIPT BRACKETS.
- Place an M5 Nylock Nut on each end of the screw.
- Using an open wrench, tighten the screw to the nut as tight as possible.
Related Products
